Select this choice to view or reset IMM to the default settings.
- Reset IMM
Select this choice to reset IMM.
– Recovery
Select this choice to view or change the system recovery parameters.
- POST Attempts
Select this choice to view or change the number of attempts to POST.
v POST Attempts Limit
Select this choice to view or change the Nx boot failure parameters.
- System Recovery
Select this choice to view or change system recovery settings.
v POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
v POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
v Reboot System on NMI
Select this choice to enable or disable restarting the system whenever a
nonmaskable interrupt (NMI) occurs. Enable is the default.
v Halt on Severe Error
Select this choice to enable or disable the system from booting into OS,
displaying the POST event viewer whenever a severe error was detected.
Disable is the default.
– Storage
Select this choice to view or change the storage device settings.
– Network
Select this choice to view or change the network device options, such as
iSCSI.
– Drive Health
Select this choice to view the status of the controllers installed in the blade
server.
v Date and Time
Select this choice to set the date and time in the server, in 24-hour format
(hour:minute:second).
This choice is on the full Setup utility menu only.
v Start Options
Select this choice to view or change the start options, including the startup
sequence, keyboard NumLock state, PXE boot option, and PCI device boot
priority. Changes in the startup options take effect when you start the server.
The startup sequence specifies the order in which the server checks devices to
find a boot record. The server starts from the first boot record that it finds. If the
server has Wake on LAN hardware and software and the operating system
supports Wake on LAN functions, you can specify a startup sequence for the
Wake on LAN functions. For example, you can define a startup sequence that
checks for a disc in the CD-RW/DVD drive, then checks the hard disk drive,
and then checks a network adapter.
This choice is on the full Setup utility menu only.
v Boot Manager
Chapter 3. Configuring 109
To Next Page
Loading...
Need help?
General