IBM x3550 M4 Type 7914 User Manual

b. Adjust the latch to the locked position on 3.5-inch server models.
4. Connect the signal and power cables to the system board. Route the signal
cable from the drive backplane along the chassis and connect it to the
SAS/SATA signal connector. Then, route the power cable from the drive
backplate assembly along the chassis and connect it to the simple-swap SATA
power connector. See “Cabling backplane” on page 199 for more information.
5. Reinstall the hard disk drives and filler panels (see “Replacing simple-swap
hard disk drives” on page 223).
6. Install the cover (see “Replacing the cover” on page 209).
7. Slide the server into the rack.
8. Reconnect the power cords and any cables that you removed.
Figure 184. Backplate assembly installation
Figure 185. Latch adjustment
292 IBM System x3550 M4 Type 7914: Installation and Service Guide

IBM x3550 M4 Type 7914 Specifications

General

Brand	IBM
Model	x3550 M4 Type 7914
Category	Server
Language	English