102
12
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION REF.
“NO POSITION”
and “NO TIME” are
displayed instead of
the position and time.
• A GPS receiver is not
correctly
connected.
• The position and time have not been
manually entered.
• Check the GPS receiver connection.
• Enter the position and time.
p. 92
p. 31
Sensitivity is too low,
and only strong signals
can be heard.
•
The antenna is defective or the coaxial
cable connector is shorted or cut.
• Repair the problem and then reconnect to
the antenna connector.
p. 92
The communication
cannot be established.
•
The antenna is defective or the coaxial
cable connector is shorted or cut.
• Repair the problem and then reconnect to
the antenna connector.
p. 92
The received DSC call
content is not printed
out.
•
The printer is not correctly connected, or
the paper is exhausted.
• Check the printer connection or paper. p. 92
The Voyage Data has
not been recorded.
• The Voyage Data Recorder (VDR) is not
correctly connected.
• Check the VDR connection. p. 92
The transceiver is
locked up, and does
not respond.
• A software error has occured. • Turn OFF the DC power source, and then
turn it ON again.
p. 96
The transceiver does
not work.
• The transceiver's Phase Lock Loop is
unlocked.
• Contact your dealer.
—
An alert is not received.
( An icon such as “
”
is not displayed in
the information area
and/or on the popup
screen.)
• The BAM function is turned OFF by default. • Turn ON the BAM function.
pp. 20,
88
To Next Page
Loading...
