Icom GM600 - Page 38

32
8
DSC OPERATION
■ Entering the position and time (Continued)
NOTE:
While entering:
• To move the cursor:
Rotate [CH/ENT].
• To correct the entry:
Move the cursor to the character. And
then, enter the correct character.
• To clear the entry:
Push [Y], [Z], [Ω], or [≈] to select “No
Data.” And then push [ENT].
When the following screen is displayed,
push [OK] .
• To return to the Main screen :
Push [Home] .
• To go back to the previous screen:
Push [CLR].
u Enter your UTC time.
Push
Enter
Cursor moves
Rotate
Push
(any key)
i After entering, select “Finish,” and
then push [ENT].
• The DSC screen is displayed.
o Push [MENU] to return to the Main
screen.
When position and time data are set,
Latitude, Longitude and UTC time are
displayed.
• Latitude: 25°32.1234N
• Longitude: 135°23.4321E
• UTC time: 12:00
When no position and time data are
set,
“No Position” and “No Time” are
displayed.