Icom GM600 - Page 56

50
8
DSC OPERATION
■ Sending a Non-Distress calls (Continued)
D Sending an Individual call (Continued)
When receiving an Individual call, you
can send an acknowledgment (‘Able,’
‘Unable,’ or ‘New CH’) by using the on-
screen prompts.
q When an Individual call is received:
• An alarm sounds.
• The following screen is displayed.
w Push any [Close] .
• When the BAM function (p. 20) is
OFF: Push any [Alarm OFF] .
e Push [Accept] .
Push
• Enters the DSC Task mode.
r Push [≈] to scroll the Software Key
functions.
t Select your desired action.
[ACK Able]:
Sends an acknowledgment without any
changes.
[ACK Unable]:
Sends an acknowledgment, but you
cannot make a communication.
[ACK New CH]:
Sends an acknowledgment. You can specify
the Voice Communication channel.
y Push [Call] to s end the Individual
acknowledgment.
When you push [ACK Unable] in step
t, skip step u, and go to step i.
u Hold down [PTT] to communicate.
i Push [Home]
to return to the
Main screen.
D Sending an Individual acknowledgment
• When the BAM function (p. 20) is
OFF: The backlight blinks and the
popup screen is displayed.
Push any [Alarm OFF]
, and
then push any [Close Call RCVD
Window]
.
When the BAM function is OFF.
When you receive “ACK (Unable)” in
step !0, skip step
!1 , and go to step !2.
!1 Hold down [PTT] to communicate.
!2 Push [Home]
to return to the
Main screen.
NOTE:
After receiving the acknowledgment:
• The voice channel specied in step u is
selected.
• A different voice channel is selected if the
station you called cannot use the channel.