35
■ Operating CW
q Connect a paddle, straight key or external elec-
tronic keyer as on page 18.
w Push and hold
F-INP ENT
BAND
for 1 sec., then push a
band key to select the desired band.
e Push
MODE
to select CW mode.
• After CW mode is selected, push and hold
MODE
for
1 sec. to toggle between CW and CW-R modes.
r Rotate [DIAL] to tune in a desired signal with the
desired tone frequency.
• The S-meter indicates received signal strength when
signal is received.
t Rotate the [AF] control to set audio to a comfort-
able listening level.
y Set CW break-in operation and the CW delay time
in the set mode. (p. 79)
q Push and hold
M-CH/RIT
SET
for 1 sec. twice to enter
the set mode.
w Rotate [M-CH] to select “BK-IN” to set the CW
break-in operation.
e Rotate [DIAL] to select the CW break-in opera-
tion from full break-in, semi break-in or OFF.
• FL : full break-in
• SE : semi break-in
• OF : break-in OFF
r Rotate [M-CH] to select “BK-DELAY” to select
the CW delay time when semi break-in operation
is selected in step e.
t Rotate [DIAL] to set the desired delay time.
y Continue to set the keyer settings in the set
mode, if necessary. (p. 80)
u Push
M-CH/RIT
SET
to exit the set mode and return to
normal operation.
u Keying to transmit, use the paddle, straight key or
external electronic keyer to send your CW signals.
• “ ” appears.
• The Po meter indicates the transmit power strength.
i Stop keying to return to receive.
To Next Page
Loading...
