84
11
MENTENANCE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
■ Memory backup
All of the CPU’s memory is backed up by an EEP-
ROM (Electronically-Erasable Programmable Read-
Only Memory). All data you set, such as VFO,
memory, set mode contents, etc. are stored in this
EEPROM. There is no internal lithium battery.
■ Resetting the CPU
q Make sure the transceiver power is OFF.
w While pushing and holding
F-INP ENT
BAND
and
M-CL
,
push to turn power ON.
• The internal CPU is reset, and all memory data are
cleared.
• The transceiver displays its initial VFO frequencies
when resetting is complete.
e All quick set mode/set mode settings are returned
to default values. (p. 70)
Resetting CLEARS all programmed contents in
memory channels and returns default values in
quick set mode/set mode.
■ Cleaning
If the transceiver becomes dusty or dirty,
wipe it clean with a dry, soft cloth.
AVOID the use of strong chemical sol-
vents such as paint, thinner, benzene or
alcohol to clean the transceiver. These
may damage the transceiver’s surfaces.
To Next Page
Loading...
