7
61
MEMORY OPERATION
■Memory channels
The transceiver has 201 memory channels including
2 scan edge channels.
Memory mode is very useful for quickly changing to
often-used frequencies.
All 201 memory channels are tuneable which means
the programmed frequency can be tuned temporarily
with [DIAL], etc., in memory mode.
MEMORY
CHANNEL
MEMORY
CHANNEL
NUMBER
CAPABILITY
COPY
TO VFO
OVER-
WRITING
CLEAR
Regular memory
channels
1–199
Independent transmit and receive frequencies
and mode in each memory channel.
Yes Yes Yes
Scan edge
memory channels
P1, P2
One frequency and one mode in each memory
channel as scan edges for programmed scan.
Yes Yes No
■Memory channel selection
q Push
V/M
➔
to select memory mode.
• “ ” appears.
w Rotate [M-CH] to select the desired memory
channel.
• If the RIT control indicator lights orange, push
M-CH/RIT
SET
to set the [M-CH] control to memory chan-
nel control. (See below for details)
• All memory channels including blank channels can be
selected.
•
[UP]/[DN] on the microphone also selects the mem-
ory channels. (The only programmed memory chan-
nels are selectable.)
About the [M-CH] control:
When the RIT control indicator lights orange, the
memory channels cannot be selected with rotat-
ing the [M-CH] control because the [M-CH] con-
trol acts as the RIT control. So, push
M-CH/RIT
SET
to
set the [M-CH] control to memory channel control
(RIT control indicator goes out).
To Next Page
Loading...
