43
4
RECEIVE AND TRANSMIT
■ Data mode (SSTV/PSK31) operation
When operating SSTV or PSK31 with your PC soft-
ware, consult the manual that is supplied with the
software.
q Connect a PC to the transceiver. (p. 20)
w Push and hold
F-INP ENT
BAND
for 1 sec., then push a
band key to select the desired band.
e Push
MODE
to select SSB or AM mode.
• After SSB mode is selected, push and hold
MODE
for
1 sec. to toggle between USB and LSB modes.
r Turn data mode ON in the quick set mode.
q Push and hold
M-CH/RIT
SET
for 1 sec. to enter the
quick set mode.
w Rotate [M-CH] to select “DATA” to set the data
mode.
e Rotate [DIAL] to select the data mode ON or
OFF.
• “ ” appears when the data mode is turned ON.
r Push
M-CH/RIT
SET
to exit the quick set mode and
return to normal operation.
t Rotate [DIAL] to tune in a desired signal and de-
coded correctly.
• The S-meter indicates received signal strength when
a signal is received.
• Also use the tuning indicator of the software.
• During SSB data mode, ¼ tuning function can be
used for critical tuning.
y Use the PC (software) to transmit.
• When operating in SSB data mode, adjust the AF
output level from PC so that the ALC meter reading
doesn’t go outside the ALC zone.
NOTE: When the data mode is selected, the
audio input from the [ACC] connector* is used for
transmission instead of [MIC] connector.
The speech compressor function is turned OFF
for the SSB data mode transmission.
* The desired connector can be selected in the set
mode. (p. 77)
To Next Page
Loading...
