105
CONTROL COMMAND
14
D Command table (continued)
#MD 3UBCMD Data $ESCRIPTION
1A 05 0074 00 Send/read Normal selection for paddle po-
larity
01 Send/read Reverse selection for paddle
polarity
0075 00 Send/read Straight selection for keyer type
01 Send/read BUG-Key selection for keyer
type
02 Send/read ELEC-Key selection for keyer
type
0076 00 Send/read Mic. up/down keyer OFF
01 Send/read Mic. up/down keyer ON
0077 00 Send/read 1275 Hz selection for RTTY
mark frequency
01 Send/read 1615 Hz selection for RTTY
mark frequency
02 Send/read 2125 Hz selection for RTTY
mark frequency
0078 00 Send/read 170 Hz selection for RTTY shift
width
01 Send/read 200 Hz selection for RTTY shift
width
02 Send/read 425 Hz selection for RTTY shift
width
0079 00 Send/read Normal selection for RTTY key-
ing polarity
01 Send/read Reverse selection for RTTY
keying polarity
0080 00 Send/read RTTY decode USOS OFF
01 Send/read RTTY decode USOS ON
0081 00 Send/read “CR,LF,CR+LF” selection for
RTTY decode new line code
01 Send/read “CR+LF” selection for RTTY
decode new line code
0082 00 Send/read 2 lines selection for number of
RTTY decoder line
01 Send/read 3 lines selection for number of
RTTY decoder line
0083 00 Send/read Scan speed low
01 Send/read Scan speed high
0084 00 Send/read Scan resume OFF
01 Send/read Scan resume ON
0085 00 to 09 Send/read NB depth
(00=1 to 09=10)
0086 0000 to
0255
Send/read NB width
(0000=1 to 0255=100)
0087 0000 to
0255
Send/read VOX gain
TO
0088 0000 to
0255
Send/read ANTI-VOX gain
TO
0089 00 to 20 Send/read VOX delay time
(00=0.0 sec. to 20=2.0 sec.)
0090 00 Send/read VOX voice delay OFF
01 Send/read Short selection for VOX voice
delay
02 Send/read Mid selection for VOX voice
delay
03 Send/read Long selection for VOX voice
delay
06 see p. 108 Send/read DATA mode selection
#MD 3UBCMD Data $ESCRIPTION
1B 00 see p. 108 Send/read Repeater tone frequency
01 see p. 108 Send/read Tone squelch frequency
1C 00 00 Send/read Transceiver’s status (RX)
01 Send/read Transceiver’s status (TX)
01 00 Send/read Antenna tuner OFF (through)
01 Send/read Antenna tuner ON
02 Send/read Manual tuning selection
02 00 Send/read Transmit frequency monitor
check OFF
01 Send/read Transmit frequency monitor
check ON
1E 00 Read number of available TX frequency
band
01 see p. 106 Read TX band edge frequencies
02 Read number of user-set TX frequency
band
03 see p. 106 Send/read User-set TX band edge fre-
quencies
To Next Page
Loading...
