16
4
MEMORY OPERATION
NOTE: When entering a memory name to the programmed
memory channel, operate as follow.
q Select the desired memory channel that requires a name.
(see p. 12).
For the IC-A14
w Push [FUNC], then push [MW](MR).
• The selected memory contents copied into frequency mode and
frequency mode is selected automatically.
e Push [FUNC], then push [MW](MR) again.
r Push [MR] momentarily to select memory name entry
mode.
t Perform the steps t and y described at left page in “For
the IC-A14” to enter the desired memory name.
For the IC-A14S
w Hold down [MR] for 1 second.
• The selected memory contents copied into frequency mode and
frequency mode is selected automatically.
e Hold down [MR] for 1 second again.
r Push [MR] momentarily to select memory name entry
mode.
t Perform the steps t and y described at left page in “For
the IC-A14S” to enter the desired memory name.
■ Copying memory contents
This function copies a memory channel’s contents into the
frequency mode. This is useful when searching for signals
around a memory channel’s frequency.
q Push [MR] to select the memory mode.
w Select the desired memory channel to be copied using
[Y]/[Z]
(or keypad and [ENT], For the IC-A14 only).
• Select the desired bank if desired.
For the IC-A14
e Push [FUNC], then push [MW](MR) to copy the memory
channel’s contents into the frequency mode.
• Frequency mode is automatically selected.
For the IC-A14S
e Hold down [MR] for 1 second to copy the memory chan-
nel’s contents into the frequency mode.
• Frequency mode is automatically selected.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
To Next Page
Loading...
Need help?
General
