Icom IC-A14

■ Weather channel scan
(Available with the IC-A14 only)
q Push [FUNC], then push [WX](7) to enter the weather
channel mode.
w Set squelch to the point where noise just disappears with
[SQLY]/[SQLZ].
e Push [FUNC], then push [SCAN] (2) to start the scan.
• When a signal is received, the scan pauses until it disappears.
• To change the scanning direction, push [Y]/[Z].
r To stop the scan, push [CLR].
■ Memory scan
NOTE: Program 2 or more memory channels with a “TAG”
setting to start a memory scan.
q Push [MR] to enter the memory mode.
• For the IC-A14, select the desired BANK if desired. (p. 12)
w Push [SQLY]/[SQLZ] to set the squelch level to the point
where noise just disappears.
For the IC-A14
e Push [FUNC], then push [SCAN] (2) to start the scan.
• When a signal is received, the scan pauses until the signal dis-
appears.
• To change the scanning direction, push [Y]/[Z].
For the IC-A14S
e Hold down [Y]/[Z] for 1 second to start the scan.
• When a signal is received, the scan pauses until the signal dis-
appears.
• To change the scanning direction, push [Y]/[Z].
19
5
SCAN OPERATION
Decimal point blinks during a
scan.
[FUNC]
[SCAN](2)
[WX](7)
[Y]
[Z]
Decimal point blinks during a
scan.
[FUNC]
[MR]
[SCAN](2)
[Y]
[Z]
r To stop the scan, push
[CLR].