Icom IC-M801E

46
11
SET MODE
2001 NEW
DD
Initial set mode items (continued)
Modulation input/output selection
This item selects the input/output terminal for signals
to/from an external unit, such as a TNC (Terminal
Node Controller).
(default: AF/MOD)
*** SET MODE ***
AF/MOD
ACC
MIC
ÇÇ
ITEM SEL
ACC out
This item toggles signal output from [AF/MOD] (pins
6–8; KEY, 13.6 V and ALC signals) ON and OFF.
• OFF : No signal is output from pins 6–8 of
[AF/MOD]. (default)
• ON : KEY, 13.6 V and ALC signals are output
from pins 6–8, respectively.
*** SET MODE ***
OFF
ON
ÇÇ
ITEM SEL
Position indication type
Select the position indicating type from simple and de-
tail.
• SIMPLE : Hides second digits (default)
• DETAIL : Shows second digits
*** SET MODE ***
SIMPLE
DETAIL
ÇÇ
ITEM SEL
Offset time
Set the offset time between the UTC and local time
within –12:00 to +12:00 in 10 minutes steps.
(default: 0:00)
*** SET MODE ***
ITEM SEL
Automatic print out
This item turns the automatic print out function ON
and OFF when receiving a DSC call.
• OFF : Prints out the received DSC contents
manually.
• ON : Prints out the received DSC contents
automatically. (default)
*** SET MODE ***
OFF
ON
ÇÇ
ITEM SEL
REMOTE connector interface
This item selects the interface format for [REMOTE]
connector. (default: NMEA)
*** SET MODE ***
NMEA
RS-232C
ÇÇ
ITEM SEL
IC-M801E_0.qxd 05.12.2 16:32 Page 46