Icom IC-R6 - Selecting Display Type

23
5
MEMORY CHANNELS
New2001
■ Selecting display type
During memory mode operation, either the programmed
bank name, memory name or the channel number can be
displayed, instead of the frequency display.
q Push [V/M] to select the memory mode.
• If desired, push [BAND] repeatedly to select a desired bank
group.
w While holding down [FUNC], push [M.N](BAND) repeat-
edly to select the display type from frequency, bank name,
memory name or the channel number.
[DIAL]
Frequency display
Bank name display
Memory name display
Channel number display
D Selecting bank channel display
During bank channel operation, the bank channel number
can also be displayed, instead of the memory channel
number.
q Select the channel number display as described to the
left.
w While holding down [BAND], rotate [DIAL] to select a
desired bank.
• The bank can also be selected by pushing [BAND] repeatedly.
Push
Memory channel
number display
Bank channel
number display
Bank channel
number display
Auto write channel
number display
W h e n t h e s e l e c t e d
memory channel has
not been programmed
with th e bank na m e
or memory name, the
frequency is displayed.