Icom IC-R6 - Priority Watch Operation Modes

26
5
MEMORY CHANNELS
New2001
5
■ Transferring memory contents
The contents of programmed memory channels can be
transferred to other memory channels.
q Hold down [S.MW](V/M) for 1 second to enter the select
memory write mode.
• 1 short and 1 long beep sounds.
• The “ ” icon and memory channel number blink.
• Do not hold down [S.MW](V/M) for more than 2 seconds.
Otherwise the memory contents will be copied to the VFO.
w Rotate [DIAL] to select a desired memory channel to be
transferred.
e While holding down [MODE], rotate [DIAL] to select the
“CLEAR” item, then release [MODE].
• Pushing [MODE] repeatedly also selects the “CLEAR” item.
r Hold down [S.MW](V/M) for 1 second.
• The displayed contents are cleared.
CONVENIENT!:
Instead of doing steps e and r, while holding down
[FUNC], pushing and holding [S.MW](V/M) for 1 second
also clears the contents.
t Rotate [DIAL] to select a desired target memory channel.
y Hold down [S.MW](V/M) for 1 second to transfer the con-
tents.
[DIAL]
• Example
Transferring the contents of memory
channel 51 to channel 33.
Steps q and w
Step e
Step r
Step t
Step y