Icom IC-R6 User Manual

39
7
PRIORITY WATCH
New2001
■ Priority watch operation
D Memory channel/memory scan watch
q Select the VFO mode; then, set an operating frequency.
w Select the channel(s) to be watched.
For a memory channel watch:
Select a desired memory channel.
For a memory scan watch:
➥ Push [V/M] to select the memory mode.
➥ Hold down [SCAN](MODE) for 1 second to enter the
scan type selection mode.
➥ Rotate [DIAL] to select a desired scan type, then push
[SCAN](MODE) again to start the memory/bank scan.
e Hold down [SET](TS) for 1 second to enter the Set mode.
r Rotate [DIAL] to select the priority watch set item.
t While holding down [FUNC], rotate [DIAL] to select “ON.”
• Select “BELL” if the priority beep function is desired.
[DIAL]
After 1 sec.
Priority ON
y Push [SET](TS) to exit the Set mode and start the watch.
• The “PRIO” icon appears.
• The receiver checks the memory/bank channel(s) every 5 sec-
onds.
• The watch resumes according to the selected scan resume set-
ting. (p. 37)
During priority watch
Monitors the VFO frequency
for 5 seconds.
Pauses on a memory
channel when a signal is
received.
During priority watch with the priority beep
A beep tone sounds and the “S” icon blinks when a
signal is received on a memory channel.
u Push [SET](TS) to cancel the watch.

Icom IC-R6 Specifications

General

Product color	Black
Channels quantity	1550 channels
Supported radio bands	AM, FM
Battery type	AA
Number of batteries supported	2
Impedance	16 Ω
Frequency range	0.1 - 1309.995 MHz
Product type	Portable CB radio
Housing material	-

Weight and Dimensions

Depth	29.8 mm
Width	58 mm
Height	86 mm
Weight	200 g