Icom ID-4100A - Page 25

10
2
PANEL DESCRIPTION
New2001
2
BASIC MANUAL
New2001
4BAND/BANK • ENTER • SCAN KEY
[BAND/BANK]/[ï]/[SCAN]
• In the VFO mode, push to enter the Band Select mode.
• In the Memory mode, push to open the Bank Select
window.
• Push to set a Menu or Quick Menu item option.
• Hold down for 1 second to open the Scan Type Select
window.
• Hold down for 3 seconds to start the last selected scan.
5VFO/MEMORY • CALL KEY [V/M]/[CALL] (p. 21)
• Push to toggle between the VFO and Memory modes.
• In the Call channel mode, push to cancel the mode.
• Hold down for 1 second to enter the Call channel mode.
6MODE KEY [MODE] (p. 22)
Push to select an operating mode.
7MEMORY WRITE KEY [MW]
• Push to open the Memory Write window.
• Hold down for 1 second to save the operating data into
a blank channel. (p. 41)
8RX CALL SIGN CAPTURE KEY [RX→CS]
• Push to display the RX>CS screen.
• Hold down for 1 second to set the received station call
sign as the destination (UR) call sign.
L See the D-STAR Guide that comes with the transceiver for
details.
9MONITOR KEY [MONI]
Push to turn the Monitor function ON or OFF. (p. 19)
QUICK MENU • MUTE KEY [QUICK]/[MUTE]
• Push to open the Quick Menu window. (p. 20)
• Hold down for 1 second to turn the Mute function ON or
OFF.
SQUELCH CONTROL [SQL] (p. 19)
Adjusts the squelch level.
L Normally, set the squelch level to where noise and the
“BUSY” icon just disappear. (closed)
L The RF attenuator activates and increases the attenuation
when rotated clockwise at beyond the center position.
POWER • SPEECH KEY [ ]/[SPCH]
• Push to audibly announce the displayed frequency,
operating mode or call sign. (p. 25)
• Hold down for 1 second to turn the transceiver ON or
OFF. (p. 19)
VOLUME CONTROL [VOL] (p. 19)
Adjusts the audio volume level.