45
6
SCAN OPERATION
New2001 New2001
BASIC MANUAL
■ Memory scan
NOTE: Two or more memory channels, which are not set
as Skip channels, must be entered to start a Memory scan.
1. Push [V/M] several times until you enter the Memory
mode.
2. Hold down [SCAN] for 1 second.
• Opens the Scan Type Select window.
L If you hold down [SCAN] for 3 seconds, the last selected
scan starts.
3. Rotate [DIAL] to select a scan type, then push [ï].
• The scan starts.
L The decimal point and blink.
L When receiving a signal, the S-meter displays the received
signal strength.
4. Push [SCAN].
• Cancels the scan
D Scan type
The Memory mode scan has 5 scan types.
• ALL: Full scan
• BAND: Band Memory scan
• MODE: Mode Memory scan
• DUP: Duplex scan
(Displayed only when duplex is set.)
• TONE: Tone scan
(For the Tone squelch scanning)
L The channels that are set as a Skip channel (PSKIP or
SKIP) are skipped during a scan. (p. 46)
L When two or more Memory channels, which are not
set as Skip channels, are entered, the Memory scan is
usable. See the Advanced manual for details. (Section 2)
TIP:
• During a scan, rotating [DIAL] switches the scanning
direction.
• The scan continuously runs, even if you push [MENU] or
[QUICK] during a scan.
To Next Page
Loading...
