Icom ID-4100A

New2001
53
New2001New2001
MAINTENANCE
9
BASIC MANUAL
■ Resetting
Occasionally, erroneous information will be displayed when,
for example, rst applying power. This may be caused
externally by static electricity or by other factors. If this
problem occurs, turn OFF the transceiver. After waiting a
few seconds, turn ON the transceiver again. If the problem
is still there, perform a Partial reset or an All reset.
A Partial reset resets the operating settings to their default
values (VFO frequency, VFO settings, menu contents)
without clearing data as listed below:
Memory channel contents Scan Edge contents
Call channel contents Call sign memories
Message data DTMF memory contents
GPS Memory contents Repeater list
BE CAREFUL! An All reset clears all programming and
returns all settings to their factory defaults. After All
Resetting, you cannot use the DR function because the
Repeater List contents are also cleared.
See the Advanced manual for details. (Section 10)
D Partial Reset
Others > Reset > Partial Reset
1. Push [MENU].
2. Rotate [DIAL] to select “Others,” then push [ï].
• Displays the OTHERS screen.
3. Select “Reset,” then push [ï].
• Displays the RESET screen.
4. Select “Partial Reset,” then push [ï].
• The conrmation dialog “Partial Reset?” is displayed.
5. Select <YES>, then push [ï].
• When the partial reset is completed, “PARTIAL RESET” is
displayed, then the display automatically returns to the default
screen.