Icom ID-4100A

28
4
MENU SCREEN
New2001
4
BASIC MANUAL
New2001
TIP: To return to the default setting:
1. Push [QUICK] in step 4.
2. Select “Default,” then push [ï].
D Selecting a Menu item
Example: Set the “Auto Power OFF” item to “30 min.”
Time Set > Auto Power OFF
1. Push [MENU].
2. Rotate [DIAL] to select “Time Set,” then push [ï].
3. Select “Auto Power OFF,” then push [ï].
4. Select “30min,” then push [ï].
• Sets the option, then goes back a tree level.
(TIME SET screen is displayed.)
5. Push [MENU].
• Returns to the standby screen.
■ Menu items and their details
This topic describes the Menu items and their details.
See the Advanced manual for details. (Section 9)
DUP/TONE...
Settings to access repeaters.
Offset Freq
Sets the frequency offset for duplex (repeater) operation.
Repeater Tone
Selects a tone frequency used to access the repeaters.
TSQL Freq
Selects a tone frequency for the Tone Squelch or the Pocket Beep
function.
Tone Burst
Turns the Tone Burst function ON or OFF.
This function is used to suppress the squelch tail noise of FM
mode on the RX side, if you transmit a signal which superimposes
the CTCSS tone or subaudible tone.
DTCS Code
Selects a DTCS (both encoder/decoder) code for DTCS Squelch
or the Pocket Beep function.
DTCS Polarity
Selects the DTCS polarity for the DTCS Squelch or the Pocket
Beep function.
Digital Code
Selects a digital code for the Digital Code Squelch function.