Icom ID-4100A - Selecting the Operating Band; Selecting the Operating Mode

22
3
BASIC OPERATION
New2001
3
BASIC MANUAL
■ Selecting the operating band
The transceiver can receive on the AIR, 144 MHz, 230 MHz,
300 MHz, and 430 MHz bands.*
You can transmit on only the amateur band frequencies.
*Selectable band differs, depending on the transceiver’s version.
1. Push [V/M] several times until you enter the VFO mode.
2. Push [BAND].
• Enters the Band Select mode.
3. Rotate [DIAL] to select an operating band.
4. Push [ï].
• Sets the band, then returns to the standby screen.
■ Selecting the operating mode
The transceiver has a total of 5 operating modes, AM, AM-N,
FM, FM-N, and DV.
By pushing [MODE], you can select an operating mode.
InformationL
• You can select the AM mode for only the AIR, 230 MHz,
and 300 MHz bands.
• You can select the AM-N mode for only the AIR band.
• You can select the FM, FM-N, or DV modes for only the
144 MHz, 230 MHz, 300 MHz, and 430 MHz bands.
• While in the FM-N mode, the TX modulation is
automatically set to narrow (approximately ±2.5 kHz).
• When you set the “GPS TX Mode” item to “D-PRS” or
“NMEA,”
is displayed besides the mode icon. See the
Advanced manual for details. (Section 5)
TIP: You can select the operating band in the Quick Menu
window.
1. Push [QUICK].
2. Rotate [DIAL] to select “Band Select,” then push [ï].
3. Select an operating band, then push [ï].
[MODE][V/M][DIAL]
[BAND]/[ï]