Icom ID-4100A

New2001
41
New2001New2001
MEMORY OPERATION
5
BASIC MANUAL
■ Entering Memory channels
The transceiver has a total of 1000 Memory channels to
save often-used frequencies.
In the Memory mode, you can quickly select the saved
frequencies.
This section describes the basic channel content entry.
Example: Entering 146.030 MHz/FM mode into a blank
channel.
Hold down [MW] for 1 second.
• The memory contents are briey displayed, then the operating
data is saved into a blank channel.
■ Checking the Memory contents
You can check the Memory contents on the MEMORY LIST
screen.
Example: Checking the contents of Memory channel 5.
Manage Memory > Memory CH
1. Push [MENU].
2. Rotate [DIAL] to select “Manage Memory,” then push
[ï].
3. Select “Memory CH,” then push [ï].
• Displays the MEMORY CH screen.
4. Select “ALL,” then push [ï].
• Displays the ALL screen.
5. Select “005,” then push [ï].
• Displays the data in Channel 5 on the MEMORY CH (005CH)
screen.
L You can select a page by rotating [DIAL].
6. Push [MENU].
• Returns to the standby screen.
TIP: To enter content into the selected channel, see the
Advanced manual for details. (Section 2)