Icom ID-4100A - Setting a Frequency; Selecting a Tuning Step

23
3
BASIC OPERATION
New2001 New2001
BASIC MANUAL
■ Setting a frequency
D Selecting a tuning step
If you select the operating frequency by rotating [DIAL]
in the VFO mode, the frequency changes in the selected
tuning step.
L The VFO mode scan and the Band Scope function also
use this step to search for a signal.
1. Push [QUICK].
2. Rotate [DIAL] to select “TS,” then push [ï].
3. Select a tuning step, then push [ï].
Options (kHz):
5.0 6.25 8.33* 10.0 12.5 15
20 25 30 50 Auto*
*Selectable only in the AIR band mode.
• Sets the tuning step, then returns to the standby screen.
L You can set the tuning step for both the VFO and Memory
mode.
L You can set the tuning step for each band.
D Selecting the 1 MHz tuning
You can change the operating frequency in ‘MHz’ steps for
quick tuning.
1. Push [QUICK].
2. Rotate [DIAL] to select “MHz,” then push [ï].
• Enters the 1 MHz Tuning Select mode.
3. Rotate [DIAL].
• The frequency changes in 1 MHz steps.
4. Push [ï].
• Sets the frequency, then returns to the standby screen.
[QUICK][DIAL]
[ï]