Icom IP730D - D Receiving and Transmitting

3
USING THE CELLULAR MODE
3-3
Basic operation (Continued)
D Selecting a call-to party
1� Push [Address] to display the Address book�
L The Address book is displayed�
2� Push [Address] several times to toggle the call type�
L The selectable call type may di󰀨er, depending on a presetting.
3� Rotate Rotary Selector or push [▲] or [▼] to select a call-to party.
D Receiving and transmitting
Receiving:
z When a Call is received, the Status indicator lights green�
Transmitting:
z While holding down [PTT], speak at your normal voice level�
L The Status indicator lights red while [PTT] is pushed�
Talk while receiving a call:
z While receiving a call, push [PTT] to talk in the Full-Duplex mode* like a telephone
call�
L In the Full-Duplex mode, the Status indicator lights yellow�
* Usability depends on a presetting� Ask your dealer for details�
IMPORTANT:
To maximize the readability of your signal:
1� After pushing [PTT], pause briefly before you start speaking�
2� Hold the microphone 5 ~ 10 cm (2 ~ 4 inches) from your mouth, then speak at
your normal voice level�
About the call type:
• All call: Transmit to all of the transceivers that belong to the network�
• Group call: Transmit to the transceivers that belong to the same group�
• Talkgroup call: Transmit to the transceivers that belong to the same
Talkgroup�
• Individual call: Transmit to an individual transceiver�
• Telephone call: Transmit to an IP phone�*
*Transmittable, depending on a presetting�
About the Time-out Timer:
If continuous transmission exceeds the preset Time-Out Timer time, the transmission
is cut o󰀨. Release [PTT], and then hold down again to resume talking.