Icom IP730D - Section 6 SET MODE; Using the Set Mode; D Basic Set Mode; D Detailed Set Mode

6
SET MODE
6-2
Using the Set mode
You can use the Set mode to set infrequently changed values or function settings�
The transceiver has 2 types of Set modes, as shown below�
L You cannot transmit or receive while the transceiver is in the Set mode�
D Basic Set mode
1� Turn OFF the transceiver, if it is turned ON�
2� While holding down [FUNC], rotate [VOL] to turn ON the transceiver�
• The Set mode is displayed�
L Release nger from [FUNC] when “SET” is displayed.
3� Rotate Rotary Selector or push [▲] or [▼] to select an item group “Common,”
“Cellular,” or “IDAS,” and then push [FUNC].
L Select “Certification” and then push [FUNC] to display certification information.
D Detailed Set mode
1� Turn OFF the transceiver, if it is turned ON�
2� While holding down [FUNC] and [Address], rotate [VOL] to turn ON the
transceiver�
• The Detailed Set mode is displayed�
L Release nger from [FUNC] when “SET (Detail)” is displayed.
3� Rotate Rotary Selector or push [▲] or [▼] to select an item group “Common,”
“Cellular,” or “IDAS,” and then push [FUNC].
D Using the Set mode
Example: Disabling the key touch beep.
1� Turn OFF the transceiver, if it is turned ON�
2� While holding down [FUNC] and [Address], rotate [VOL] to turn ON the
transceiver�
• The Detailed Set mode is displayed�
L Release nger from [FUNC] when “SET (Detail)” is displayed.
3� Rotate Rotary Selector or push [▲] or [▼] to select an item group “Common,” and
then push [FUNC]�
4� Push [FUNC] or [Address] several times to select “Key-Touch Beep.”
5� Rotate Rotary Selector or push [▲] or [▼] to select “OFF.”
6� Push [CLR/Lock] to exit “Key-Touch Beep.”
L Push [CLR/Lock] again to exit the Set mode and return to the Standby screen�
SET
SET MODE
Common
SET(Detail)
SET MODE
Common
SET(Detail)
Key-Touch Beep
OFF