6.2 How do I reset the password?
Reset the Administrator password, the network, and web server settings to
the original factory default values by doing the following (the standard user
password and other settings are not affected):
• Press and hold either "Output Select" button on the front panel for
approximately 20 seconds until "Resetting" is shown on the front
panel display (see Section 3.3 or Section 4.11).
• Release the button.
6.3 How do I receive e-mails from the unit?
• See Section 4.8 E-MAIL SETUP.
• Verify that the "Send E-mail" check boxes are selected for any alarm
conditions for which the user wishes to receive e-mail notifications.
• Verify the e-mail settings by going to the "Maintenance" tab on the
unit’s GUI and clicking on the "Send Test E-mail" button to send a
test message to the designated recipient addresses. The "Send
Test E-mail" page will show an error message if the system is
unable to send the e-mail.
• Check on the "E-mail Setup" page and ensure that the "SMTP
Server" field is the correct address for the e-mail provider, and that
the "SMTP Port" is correct (Port should be 25 for most servers).
• If the SMTP server requires SSL encryption, ensure that the "SMTP
Server requires SSL" checkbox is ticked. Otherwise leave it blank.
• If the SMTP server requires authentication, ensure that the "SMTP
User Name" and "SMTP Password" fields are correctly entered.
6.4 How do I configure a router?
To set up the ICT Dual Bus Distribution Panel Series 3 with remote internet
access when it is located behind a router, Port Forwarding will need to be
enabled on the router to forward incoming HTTP or HTTPS traffic to the
local IP address of the unit. Refer to your router's user manual for
instructions on how to configure Port Forwarding.
6.5 How do I receive text message alarm notifications?
The unit can send alarm notifications as text messages to a cell phone by
configuring the alarm e-mails to be sent to the mobile phone service
provider.
On the "E-mail Setup" page of the GUI enter the address of the phone in the
"Recipient E-mail Address" field. Example with an AT&T phone: enter the
recipient address "cellnumber@txt.att.net", replacing "cell number" with the
10-digit cell phone number.
To Next Page
Loading...
Need help?
General
