ICT Distribution 3 Series User Manual

Distribution Series 3 Dual Bus
855-314-002_Rev2.0_Instruction Manual
Page 30 of 46
Authentication Password: If an authentication protocol is selected, set
the authentication password.
Privacy Protocol: Set the SNMPv3 privacy protocol (None, or AES).
Privacy Password: If a privacy protocol is selected, set the privacy
password.
SNMP Traps:
Trap Version: Set the SNMP version (v1 or v3) for SNMP traps sent
from the system. The appropriate settings for the selected SNMP version
will need to be configured.
Trap Community: Set the community string/password that will be sent
with all SNMPv1 traps. Some trap receivers can filter based on Trap
Community. This field is only used for v1 traps.
Trap User Name: Set the username for SNMPv3 traps. This field is only
used for v3 traps.
Authentication Protocol: Set the authentication protocol for SNMPv3
traps (None, MD5, or SHA)
Authentication Password: If an authentication protocol is selected, set
the authentication password for SNMPv3 traps.
Privacy Protocol: Set the privacy protocol for SNMPv3 traps (None, or
AES)
Privacy Password: If a privacy protocol is selected, set the privacy
password for SNMPv3 traps.
Trap IP Addresses: Set the IP addresses for up to two devices that will
receive SNMP traps from the unit.
NOTE: Save Settings to enable any changes made.
4.8 E-mail Setup
Use this tab to configure all e-mail settings to enable automatic e-mail
notifications directly from the unit. The information required for this is
available from the Network Administrator, or Internet Service Provider (ISP).

ICT Distribution 3 Series Specifications

General

Brand	ICT
Model	Distribution 3 Series
Category	Power distribution unit
Language	English