Send E-mail: Set the check box to have a Bus Over-Current alarm e-
mail sent to the e-mail addresses set up on the "E-mail Setup" page (see
Section 4.8). The default setting is Disabled.
NOTE: Save Settings to enable any changes made.
4.6 Output Setup
Use this tab to configure the settings for each output channel on Bus A and
Bus B.
Select an Output to edit
Select the output to be edited in this section. Make any required changes,
and then click on the "Save Settings" button at the bottom of the page to
save any edits.
Output Settings
Output Label: Enter a descriptive label for the selected output channel.
The default setting is blank.
Output State after Panel Reset: Sets the state for the output after an
input power failure, or soft reset of the panel. The default setting is
Restore Last State. Select one of the following:
• Restore Last State: This will return the output relay to the state
prior to the reset event (default).
• Enable Output: This will turn the output on, regardless of its
previous state.
• Disable Output: This will turn the output off, regardless of its
previous state.
To Next Page
Loading...
Need help?
General
