ID Technology 252 - Troubleshooting Common Issues

Model 252
Label Printer/Applicator
Operators/Technical Manual
3
4. Troubleshooting
SYMPTOM
POSSIBLE CAUSE
REMEDY
PARA.
No waste take-up
Broken/missing drive
belt
Replace drive belt
IV.10.1
Broken/missing tension
spring
Replace tension spring
IV.10.1
Label Falls Off Tamp Pad
No / Low Vacuum
Check unit is in tamp, rev.
Tampjet, or tampjet mode
III.4.4
Check Air Pressures
III.4.13.2
Check Valve Operation
III.4.13.2
Clean Tamp Pad
I.7
Pad Position not correct
Reposition Tamp Pad
III.4.13.1
Tamp Pad wrong size
Install correct Pad
III.2.9.1
No Tamp Cycle
Tamp Mode disabled
Enable Tamp Mode
III.4.4
Tamp Dwell too short
Increase Tamp Dwell
III.4.8
No Tampjet Blast
Tampjet Mode disabled
Enable Tampjet Mode
III.4.4
Blast Dwell too short
Increase Blast Dwell
III.4.9
Motor rotation wrong
Unit set to wrong hand
Change motor direction
connection
IV.6
Unwind free spins
Broken/missing tension
spring
Replace tension spring
IV.9
Broken/missing brake
band
Replace brake band
IV.9
Label Pulls off pad/sticks to
Peel tip during cycle
Label Stop too short
Adjust per printer manual
instructions
See printer
manual
Label Stop too long
Tamp pad too high
Reposition Tamp Pad
III.4.13.1