Model 252
Label Printer/Applicator
Operators/Technical Manual
72
7.1.5 Mode 5
In this mode, the dual panel module may be used to only apply a single label by only
activating cycle 2.
7.2 Dual Panel Tamp Dwell
The Dual Panel Firmware adds a second setting to the Tamp Dwell menu. There is a
setting for each action of the dual panel module and both can be changed independently.
Selecting Cycle 1 modifies the dwell settings for that cycle. Selecting Cycle 2
modifies the dwell settings for the other cycle. Pressing the key will accept both
settings and pressing the key will discard changes to both settings.
Cycle 1 and Cycle 2 are defined by the plumbing and electrical setup. Cycle
1 is controlled by connector J9 (Tamp) and cycle 2 is controlled by connector
J20(V5). Either the straight cycle or the swing cycle can be plumbed to be
cycle 1 depending on application requirements.
7.3 Dual Panel Smart Delay
The Dual Panel Firmware adds a second setting to the Smart Delay menu. There is a
setting for each action of the dual panel module and both can be changed independently.
Selecting Cycle 1 modifies the delay settings for that cycle. Selecting Cycle 2
modifies the delay settings for the other cycle. Pressing the key will accept both
settings and pressing the key will discard changes to both settings.
Cycle 1 and Cycle 2 are defined by the plumbing and electrical setup. Cycle
1 is controlled by connector J9 (Tamp) and cycle 2 is controlled by connector
J20(V5). Either the straight cycle or the swing cycle can be plumbed to be
cycle 1 depending on application requirements.
To Next Page
Loading...
