ID Technology 252 - Table of Contents

Model 252
Label Printer/Applicator
Operators/Technical Manual
I. GENERAL___________________________________________________________ 0
1. Introduction ________________________________________________________ 2
2. Initial Operation of Equipment _________________________________________ 2
3. Safety Symbols _____________________________________________________ 3
4. Safety Tips - General ________________________________________________ 5
5. Safety Tips – General Service & Maintenance _____________________________ 6
6. Safety Tips – General Electrical ________________________________________ 7
7. Cleaning Of Equipment ______________________________________________ 8
II. OPERATING FUNDAMENTALS _______________________________________ 0
1. Introduction ________________________________________________________ 1
2. Unwind Assembly ___________________________________________________ 2
3. Rewind Assembly ___________________________________________________ 2
4. Electronics Assembly ________________________________________________ 2
4.1 Operator Interface _________________________________________________ 2
4.2 PCB ____________________________________________________________ 2
4.3 Main Power Connection ____________________________________________ 2
5. Pneumatic Assembly _________________________________________________ 2
6. Optional Accessories ________________________________________________ 3
6.1 Low Label Sensor _________________________________________________ 3
6.2 Three Stage Beacon _______________________________________________ 3
6.3 System Status Output ______________________________________________ 3
6.4 TS Series Mounting System _________________________________________ 3
6.5 Tamp Module ____________________________________________________ 3
6.6 Heavy Duty Tamp Module __________________________________________ 3
6.7 Service Tamp Module ______________________________________________ 4
6.8 Tampjet Upgrade _________________________________________________ 4
6.9 Smart Tamp Sensor ________________________________________________ 4
6.10 Tamp Home Sensor_______________________________________________ 4
6.11 Swing Tamp Module______________________________________________ 4
6.12 Dual Panel Module _______________________________________________ 5
6.13 Corner Wrap Module _____________________________________________ 5
6.14 Main Air Cutoff _________________________________________________ 5
6.15 Water Separator _________________________________________________ 5
III. INITIAL SETUP _____________________________________________________ 0
1. General Specifications _______________________________________________ 1
1.1 Standard Features _________________________________________________ 1
1.2 Overall Dimensions _______________________________________________ 1
1.3 Weight __________________________________________________________ 1
1.4 Electrical ________________________________________________________ 1
1.5 Air Requirements _________________________________________________ 1
1.6 Label Roll Size ___________________________________________________ 2