EasyManuals Logo

Idexx VetTest User Manual

Idexx VetTest
132 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
$o
Sample Collection and Preparation
Storing Urine Samples
For a Urine P:C Ratio, the urine sample should be analyzed within four hours of
collection. If this is not possible, you can refrigerate the sample at
×o×$×o×'GPS
up to three days.
Analysis of Stored Samples
Serum or Plasma Samples
'PSTFSVNPSQMBTNBTBNQMFTTUPSFEBU×o×$×o×'BOEBU×$×'
"MMPXUIFTBNQMFTUPDPNFUPSPPNUFNQFSBUVSF×o×$×o×'t
Mix the samples gently, but thoroughly, by inversion. t Do not shake.
Centrifuge the samples to remove any fibrin particles that may have formed t
during storage.
Analyze the samples immediately after centrifugation. t
Urine Samples
For refrigerated urine samples, be sure the samples have come to room temperature
before analysis.
Combined Chemistry and Hematology Sample Preparation
When performing an analysis using both the chemistry and the hematology analyzers,
it is necessary to collect two tubes of blood because the sample requirements for
clinical chemistry and hematology testing are different. Chemistry testing on the VetTest
requires serum or plasma.
Note: A urine analysis on the VetTest analyzer can only be run with urine protein slides
or urine creatinine slides and when performing UPC ratios.
Hematology requires whole blood mixed with EDTA anticoagulant. We recommend
MJRVJEUSJQPUBTTJVN,
3
&%5".BLFTVSFUIFCMPPEUP&%5"SBUJPJTBQQSPQSJBUFGPMMPX
the manufacturer’s specifications).
To prepare blood for both chemistry and hematology testing:
Draw a sample into a new syringe. Do not heparinize. 1.
Without delay, gently transfer the sample into two separate tubes:2.
3FEPSHSFFOUPQQFEUVCFGPSDIFNJTUSZUFTUJOHt
EDTA tube for hematology testingt
Important: You must immediately transfer the sample to keep it from clotting.
Follow the instructions for serum or plasma sample preparation as described 3.
earlier in this section. Follow the sample preparation instructions in the
hematology analyzer’s manual for hematology sample preparation.
Important: Do not use EDTA for chemistry testing. EDTA can cause
interference with many analytes.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Idexx VetTest and is the answer not in the manual?

Idexx VetTest Specifications

General IconGeneral
BrandIdexx
ModelVetTest
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals