35
11 Parameter setting
During parameter setting the device remains in the operating mode� It continues
its monitoring functions with the existing parameters until the parameter setting
has been completed�
11.1 Parameter setting in general
1
Select parameter
► Press [Enter] to get to the menu�
► Press [▲] or [▼] until the required
parameter is displayed�
2
Set parameter value
► Press [Enter] to edit the selected
parameter�
► Press [▲] or [▼] for min. 1 s.
> After 1 s: setting value is changed:
Incrementally by pressing the button
once or continuously by keeping the
button pressed�
Numerical values are incremented continuously with [▲] or decremented with [▼]�
3
Acknowledge parameter value
► Press [Enter]�
> The parameter is displayed again�
The new setting value is saved�
Set other parameters
► Press [▲] or [▼] until the required parameter is displayed.
Finish parameter setting
► Press [▲] or [▼]
several times until the current measured value is displayed or wait for
30 s�
> The unit returns to the process value display�
[C�Loc] or [S�Loc] as operation indication see (→ 12.7)
To Next Page
Loading...