IFM VNB211 - Page 31

31
UK
Factory setting User setting
Switching logic pre-alarm Characteristic vibration value
1 or characteristic vibration
value 2 or external process
value
Switching logic main alarm Characteristic vibration value
1 or characteristic vibration
value 2 or external process
value
The following list indicates the factory settings of the parameters that can be set
via the pushbuttons on the unit:
Factory setting User setting
Characteristic vibration
value 1
SP1 (pre-alarm) 2.8 [mm/s]
rms
SP2 (main alarm) 4.5 [mm/s]
rms
AUER (averaging) 0�125
Characteristic vibration
value 2
SP1 (pre-alarm) 5 [g]
peak
SP2 (main alarm) 7.5 [g]
peak
AUER (averaging) 1
External
characteristic vibration
value 1
Not used
ESP1 (pre-alarm)
ESP2 (main alarm)
AUER (averaging)
External
characteristic vibration
value 2
Not used