The time required to transfer data depends on your network connection. Before beginning a subsequent
scan, make sure that data have been written to the output folder. To check, make sure that GTC files
are present in the barcode folder. For more information, see
Scanning Output Folder Structure
on page
63.
If the connection is interrupted, data transfer resumes automatically when the connection is restored.
Each file has a timer of 1 hour after it has been queued for transfer to the output folder. When the timer
expires or if the instrument is rebooted before transfer is complete, data are not written to the output
folder.
Document # 1000000041922 v01
For Research Use Only. Not for use in diagnostic procedures.
33
NextSeq 550Dx Research Mode Instrument Reference Guide
To Next Page
Loading...
Need help?
General
