Enter Setup
Exit and Save
Note: You do not need to scan "Enter Setup" or "Exit with Save" when reading the
barcodes below. The functions can be achieved simply by scanning the
corresponding function setting barcodes.
(*) Return to Common Mode
If you want to erase the data in buffer, scan the "Erase Buffer" barcode
(for inventory mode only)
Erase Buffer (for inventory mode only)
Scan the "Upload Data" barcode to upload the data in buffer storage
(for inventory mode only)
Upload Data (for inventory mode only)
Scan the "Upload Number Collected"barcode to upload the number of barcodes
collected (for inventory mode only)
Upload Number Collected (for inventory mode only)
When under inventory mode, if you do not want to scan the same barcode twice,
you may set the scanner as "Enable Duplicate Scan Check". After the setting, the
scanner will let out a strange "beep" sound when it reads a duplicate barcode,
and the duplicate barcode scanned will not be stored in the buffer. The scanner
To Next Page
Loading...
