Inateck BCST-43 - Barcode Type Configuration; Common Barcode Settings

Enter Setup
Exit and Save
24
Barcode Settings
Codabar
Enable/Disable Codabar
(*) Enable Codabar
Disable Codabar
Transmit START/STOP Characters
(*) Enable Codabar START/STOP
Characters
Disable Codabar START/STOP
Characters
Code 11
Enable/Disable Code 11
Enable Code 11
(*) Disable Code 11
Checksum Code
Data in a Code 11 barcode may not include the checksum code. If there is, the
checksum code is the last one or two digit(s) of the data output. The checksum
code is the value added from all data collected, to check if the data is correct.
After you set the "Code 11 without Checksum" function, the scanner can recognize
all Code 11 barcodes normally. The scanner defaults the "Code 11 without
Checksum" setting.