InFocus X1 Service Guide

X1 Service Guide 63
Power Diagnostics, part 2
Press the Power button on the keypad
Did the lamp light
and the LED turn
solid green?
Go to Error Codes
(page 64)
Is the LED
flashing
green?
No, the LED
remains
solid green.
Press the Power
button again.
The LED continues flashing
green until the lamp lights.
Yes
Yes
The Startup tone sounds.
The fans spin up, then slow.
The color wheel spins up.
This assumes you have plugged the power
cord in and that the LED is solid green. If
not, go back to Part 1 (page 62).
The LED remains solid green
after pressing the Power button
twice. The lamp does not light.
Replace keypad ECA
(page 37)
Repeat process to confirm the
problem fixed.
Run the projector long enough to ensure
that the problem is solved. If the lamp
goes out and the LED turns red, go to
error codes (page 64).
No. The lamp does
not light, and the LED
begins blinking red.
The lamp attempts to strike five times at 30-
second intervals. After 2 1/2 minutes, the
projector no longer tries to strike the lamp and
the LED begins flashing red.
Note
A solid green LED
means the projector
is either waiting for a
command or is
operating normally.
A flashing green
LED means the
projector is either
attempting to light
the lamp or is
shutting down.
Replace controller ECA
(page 19)
Solve the
problem?
No
Yes

InFocus X1 Specifications

General

Brand	InFocus
Model	X1
Category	Projector
Language	English