InFocus X1 - Page 64

X1 Service Guide 64
Power Diagnostics, Error Codes
3 flashes
The projector detected an
internal error and shutdown
the lamp.
Diagnose lamp shutdown.
(page 66)
Interpret
red LED
behavior
Flashing
Is the LED steady or
flashing?
Steady
An internal error occurred that
the projector cannot identify.
Diagnose the error.
(page 62)
What is the
flashing pattern?
Red LED flashes have
2-second intervals
between series of
flashes. For example,
the LED may flash 4
times, the pause for 2
seconds, the flash 4
times again.
On
Off
2 flashes
The lamp timer registers
lamp use of 2000 hours
or more.
Replace the lamp.
(page 42)
On
Off
1 flash
The lamp failed to strike after
five attempts.
Diagnose lamp strike failure.
(page 65)
On
Off