EonStor / EonStor DS S12/S16/S24 Series
of a powe
r outage. Once the transfer is done, all
LEDs will turn off.
signal is local to each controller. This
3. Temp. Amber
Amber indicates that the detected
CPU/board/chassis temperature has exceeded the
higher temperature threshold.
OFF indicates that the detected temperature reading
is within the safe range.
4.
St
Green steady on indicates the CBM module is ready.
Both a BBU and flash are present.
or flash has failed. When lit, it also
OFF means BBU is not installed in a single-controller
CBM
atus
Green/
Amber
modules
Amber steady on indicates CBM failure, meaning
either BBU
indicates either BBU or a flash is missing in a
redundant-controller system.
Blinking means a BBU is being charged.
“G” model.
5. Hst Bsy Green
traffic on the host bus. Blinking Green to indicate
6. Drv Bsy Green
reen to indicate traffic on the drive Blinking G
channels.
7. Restore
Default
Green
D state will be
Green indicates the RAID configuration default has
been successfully restored. The LE
invalidated after a few seconds.
129
To Next Page
Loading...
