Infortrend S12F-G1842 - Replacing 4 U RAID Systems Cooling Module

EonStor / EonStor DS S12/S16/S24 Series
164
Replacing 4U RAID Systems Cooling Module
The cooling module is secured in the chassis by a retention latch. To replace the
cooling module, follow the steps below:
WARNING!
The fan replacement process should be completed within five (5) minutes. If the
process takes too long, the accumulated heat can damage the system.
1. Use no one hand to push the retention latch to the side, while using a ther hand to
hold and pull on the fan module extraction handle.
2. Once released from the module bay, remove the faulty module.
3. Install the replacement module by pushing it gently into the module bay. You may
need to push the retention latch sideways (just as when you were removing it)
while installing the replacement module. When fully inserted, the retention latch
will hold the module in place.
162