EonStor / EonStor DS S12/S16/S24 Series
3U-R/Gx
xxx models
4U-R/Gxxxx models
Be s ure ever y P SU sh ou ld
have th e sam e mark
3Y
405 W
Be s ure e ver y P SU sh ou ld
hav e th e sam e mark
3Y
405W
Be s ur e e ver y P SU s hou ld
hav e th e sam e mark
3Y
405W
CH0 CH1
CH0 CH1
RAID controllers (1) / (2): Each RAID controller module contains a
main circuit board and a pre-installed DIMM module. For single
controllers, a dummy cage will be placed at the controller (2) position.
The host port configurations will vary. For details, see Rear Panel
Components.
WARNING
Do NOT remove the dummy cage for the single-controller model. Doing so will
disrupt the internal airflow.
Power supply unit & cooling module (3):
2U & 3U: The hot-swappable PSUs provide power to the system. There
is a cooling module within each PSU. Please refer to your
specific system for details shown in the later sections
of this
chapter.
27
To Next Page
Loading...
