Terminal User Guide
Page 15
iWL250 User Guide
Copyright© 2019 Ingenico
During normal operation the top row (showing the battery status and power status
icons, the communication status, and the signal icon) is always displayed on the
screen. Therefore all subsequent screen shots in this User Guide are shown
without this top row.
When your terminal has been powered on and after a short initialisation process
the terminal will display the terminal status of READY, this simply means that the
terminal has initialised and is ready to use.
If your terminal displays the NOT READY status message then your terminal is not
initialised. Press menu once, and choose the SETUP menu option by pressing the
F4 key. You should contact the terminal Helpdesk if the problem persists after a
successful TMS Call.
Menu System
When you press the menu key from the idle screen your terminal will enter the
menu system. All the menu screens have the same layout. To select an option
press the F1, F2, F3, or F4 keys as indicated on the screen.
When navigating around the menu structure: by pressing the menu key you will
move to the next menu screen (if available); by pressing the cancel key you will
move back to the last menu screen (if available), or return to the idle screen.
A schematic of the whole menu structure is found in the section entitled Menu
Structure.
To Next Page
Loading...
