Terminal User Guide
Page 91
iWL250 User Guide
Copyright© 2019 Ingenico
Reccomendations
Safety
Powering down the iWL250
• Disconnect the iWL250 from the base and then hold the yellow and dot key
to power off the terminal
Electrical power outlet
The electrical power outlet must meet the following criteria:
• Must be installed near the equipment and easily accessible
• Must meet the standards and regulation in the country where used
• For type G plug the fuse rating must be 5A
Explosion areas
• Certain regulations restrict the use of radio equipment in chemical plants,
fuel depots and any site where blasting is carried out. You are urged to
comply with these regulations. The terminal shall be protected by a
specially fitted and certified cover enabling use in proximity to a fuel pump.
Electronic health appliances
• The handset is a radio transmitter which may interfere with health
appliances, such as hearing aids, pacemaker, hospital equipment, etc.
• Your doctor or the equipment manufacturer will be able to provide you with
appropriate advice.
External connection
• All external circuits connected to the iWL250 must be SELV (Safety Extra
Low Voltage) and LPS (limited power source) within the meaning of section
2.2 and 2.5 of the standard IEC60950- 1:2005+/A1:2010 and EN60950-
1:2006+/A11:2009+/A1:2010+/ A12:2011
. Cleaning
• To clean the terminal, use a soft cloth slightly moistened with water. Do not
clean the electrical connections; do not use solvents, detergents or
abrasive products.
The power supply contains the following symbols:
To Next Page
Loading...
