Terminal User Guide
Page 67
iWL250 User Guide
Copyright© 2019 Ingenico
X Balance Report
The X Balance report is sometimes referred to as an End of Shift Balance report.
This is because it allows you to print a total of all transactions performed since the
last Z Balance report. The X Balance may be printed at any time throughout the
day.
Transactions are listed by card type, and by Operator ID (Waiter ID for example, if
enabled) showing transactions together with any gratuities or cashback (if
enabled) by each operator.
A list of all transactions done since the last Z Balance was completed is also
shown.
The totals within the terminal will not be reset after printing an X
Balance.
To perform an X Balance report press the menu key twice, then choose
REPORTS. You will be asked to type your supervisor password, then press green
key, choose X BALANCE and press green key.
The X Balance report is exactly the same as the Z Balance excepting the totals
are not reset.
Example X Balance report
X BALANCES
Totals Not Reset
Merchant Name
Merchant Address 1
Merchant Address 2
Please refer to the following section entitled Z balance report for more details on
the contents of the X Balances report.
To Next Page
Loading...
