Terminal User Guide
Page 12
iWL250 User Guide
Copyright© 2019 Ingenico
Battery Installation
Your terminal is supplied with a rechargeable battery pack.
In order to access the battery pack you must first remove the battery access
cover by unclipping the catches and lifting the cover as shown.
The battery connector is held into place with a moulded catch. This catch
engages automatically when the connector is pushed into place; the moulded
catch clicks into place (1). You should ensure that connector is inserted correctly
so that the red wire is closest to the side of your terminal.
To remove the battery pack press the moulded catch in and pull away the
connector (2).
If the terminal displays a battery status icon with a cross in it then a battery pack
is not installed or is installed incorrectly. You will not be able to perform
transactions if there is no battery in the terminal.
The battery pack can only be charged when it is in the terminal by using either the
charger base or the optional travel charger. For maximum efficiency it is
recommended that the battery is always charged at normal room temperature.
Your terminal intelligently charges the battery. To protect the battery if the
terminal is placed on charge when the battery is more than half full, the battery
will be charged at a slower rate than if the battery is low.
Rechargeable batteries can deteriorate over time. In the event that you
experience any issue with your battery please contact the Helpdesk.
Red
Wire
Fig. 1 Fig. 2
To Next Page
Loading...
