Terminal User Guide
Page 73
iWL250 User Guide
Copyright© 2019 Ingenico
Supervisor Functions
Supervisor password
Supervisor password
Default supervisor password is 01483
The Supervisor password is designed to limit access to the Supervisor functions
(such as the Supervisor Menus, or Refund transactions) on the terminal to those
who have access to the code.
Your terminal is shipped with an initial default code of 01483, but is configured so
that a change of this code is required before you process any transactions. If you
forget your code, please contact the terminal Helpdesk who will be able to reset
the code back to the default.
The following codes are not valid choices for your Supervisor
password: 01483, 1234, 0000, or 9999.
Any other numerical code of four or more digits will be a valid
Supervisor password.
The Supervisor password allows entry into the Refund option on
the terminal.
To change your Supervisor password press the menu key twice, then choose
SUPERVISOR from the list. You will be asked to type your current supervisor
password (i.e. 01483), then press green key, choose PASSWORD then CHANGE
PWD.
You will need to enter your new numerical code (4 digits or more) twice, pressing
the green key after each input, before the Supervisor password is updated to this
new value.
If your terminal is lost or stolen you should contact the terminal
Helpdesk immediately.
To Next Page
Loading...
