Terminal User Guide
Page 63
iWL250 User Guide
Copyright© 2019 Ingenico
To perform banking report please follow the instructions below.
To perform a Banking report for ALL
acquirers press the green key twice, then
choose REPORTS.
You will be asked to type your supervisor
password, then choose BANKING.
To perform a Banking report for ALL
acquirers choose ALL. If you are looking
to select acquirer to be banked select
SINGLE
If you selected SINGLE you will be asked
to choose an acquirer from the list.
The terminal will contact the acquirer and
display confirmation screen followed by
the banking printout.
The Banking report is a integral part of the End of Day Report. If
you do an End of Day report then you do not need to perform a
separate Banking report.
If you do not complete an End of Day report (or activate Banking
and Z Balance separately), money may not be collected from the
customer and will lead to a delay in you receiving funds
To Next Page
Loading...
