Reports Terminal User Guide
72
X Balance Report
The X Balance report is sometimes referred to as an End of Shift
Balance report. This is because it allows you to print a total of all
transactions performed since the last Z Balance report. The X Balance
may be printed at any time throughout the day.
Transactions are listed by card type, and by Operator ID (Waiter ID for
example, if enabled) showing transactions together with any gratuities
or cashback (if enabled) by each operator.
A list of all transactions done since the last Z Balance was completed is
also shown.
The totals within the terminal will not be reset after printing an X
Balance.
To perform an X Balance report press the menu key twice, then choose
REPORTS by pressing the F1 key. You will be asked to type your
supervisor password, then press enter, choose X BALANCE by pressing
the F3 key.
MENU, MENU, F1, [password], ENTER, F3
The X Balance report is exactly the same as the Z Balance excepting
the totals are not reset.
Example X Balance report
X BALANCES
Totals Not Reset
Merchant Name
Merchant Address 1
Merchant Address 2
Please refer to the following section entitled Z Balance Report for more
details on the contents of the X Balances report.
To Next Page
Loading...
