Ingenico iWL200 Series - Supervisor Password Change (Initial Transaction); Refund Password

Reports Terminal User Guide
76
Stored Report
A Stored Transaction report may be printed to show how many
transactions are stored in the terminal, awaiting transmission to the
host.
Up to five transactions may be stored in the terminal per acquirer. A
transaction may be stored after voice referral, or by using the Forced
Transaction or Hotel Mode Completion functions.
Do not print this report unless instructed to do so by the
terminal Helpdesk.
To perform a Stored report for ALL acquirers press the menu key twice,
then choose REPORTS by pressing the F1 key. You will be asked to type
your supervisor password, then press enter, press the menu key once
more, choose STORED by pressing the F1 key, followed by the F1 key to
choose ALL.
 MENU, MENU, F1, [password], ENTER, MENU, F1, F1
To perform a Stored report for a SINGLE acquirer press the menu key
twice, then choose REPORTS by pressing the F1 key. You will be asked
to type your supervisor password, then press enter, press the menu key
once more, choose STORED by pressing the F1 key, followed by the F4
key to choose SINGLE. Press F4 repeatedly for NEXT until the acquirer
required is displayed, select this by pressing enter.
 MENU, MENU, F1, [password], ENTER, MENU, F1, F4